download
REMOVAL 1. Remove saddlebags from motorcycle following the instructions in the service manual. 2. See Figure 3. Remove grab strap screw and washer (G). Remove grab strap (H). Remove seat following the instructions in the service manual. 3. Remove left and right side covers (located in front of saddlebags) by removing screw from bottom of side cover. Save hardware and side covers for final assembly. 4. Support muffler assembly with a block of wood or other suitable method. For FLTR and FLHX Models 1. See Figure 3. Remove the screws (F) securing saddlebag guards to muffler supports. 2. Remove bolt (M) and nut (P). Save bolt (M) for installation. Discard nut (P). 3. Remove screws (B and C) and nut (E). Save screws (B and C) for installation. Discard nut (E). 4. Remove stud receptacle (I) and save for installation. 5. See Figure 1. Remove antenna bracket (1), mounting fasteners (2), antenna mounting nut (5), washer (4) and antenna adapter (3). Save the antenna and hardware, discard the bracket. 6. Remove support (D) and discard. 7. Repeat Steps 1 through 4 for other side. For FLHTCU and FLHTC Models 1. Remove and discard screws (X) and guard rail mounts (W and V). 2. Remove screw (Q) and rear guards (U). Discard rear guard assembly including screws (T) and clamps (R and S). Discard screw (Q). 3. Remove and discard screw (K) and nut (L). 4. Remove screws (N and C) and nut (E). Save screw (C) for installation. Discard nut (E), screw (N) and forward guard. 5. Repeat Steps 1 through 5 for other side. For All Other Models 1. Remove screws (N and C) and nut (E). Save screw (C) for installation. Discard nut (E) and screw (N). 2. Remove and discard screw (K) and nut (L). 3. Remove forward guard and discard. 4. Repeat for other side
